FLASHES  
1   =   Test mode
2   =   1 minute
3   =   5 minutes
4   =  15 minutes
5   =  30 minutes

Press and hold the master switch in the hallway for six seconds, the stage spotlights will start flashing. Walk over to the stage spot, remote switch and press that button for six seconds and it should connect. Once the light stops flashing, you are connected. There is a slight delay in the signal transmission from when you push the button to when you see the light turn on

The dimmer is controlled by the vertical bar on the right side of the device. Set that to full on.

To set the time out press and hold the on off button until it flashes five times which would be 30 minutes.