These devices have a pair of round detectors on the front and need to have the switch plate removed to change the settings. This means they will never change during normal operation. The ones that change are simpler and program through the power switch.

Set most to default with 30 second time out

Set to default with 30 second time out

Learning Center Locations
1. 2nd Floor:  Two Control Modules are located in the ceiling.  
    A.  In the ceiling a few ceiling tiles in front of elevator.
    B. Located in the ceiling between room 202 and 203.

2. 3c's Lobby: Located in the hallway outside of the table room. In the ceiling above the tile beside the light fixture and the air vent. 

3. Lower Level: Located in the ceiling in front of the elevator.

Follow the instructions to reset and reprogram sensors.