FAQ - Campus Users

    Sanctuary HVAC

    1. 1

      Sanctuary Control

      This is a semi automated system with manual controls on many devices and WiFi accessed thermostats to Master the system.
    2. 2

      The main thermostat is located in the boiler room

      This has a remote sensor located on the north wall of the choir loft
    3. 3

      Operation Strategy

      All the univents located on the side walls are individual devices. This gives us the abilitiy to zone the space. A hand held Infrared thermoter helps in determining the temperature and cycling of each device.
    4. 4

      The three univents around the chancel

      These are left in the cool mode for all but the coldest of winter days. Generally, the lighting keeps the area warmer than the Pews.
    5. 5

      Evening A/C Control

      The Pump Override thermostat is located in the Office Basement Mechanical Room. The remote control is in the Honeywell TCC app. The override is not using temperatures, only pump control by the fan setting. If the secondary loop pump is running after its scheduled end (normally 6:00pm) the override is in control. This can be set from 6:00pm to 8:00pm without any effect on ice build. Running past 8:00pm will reduce the amount of Ice built because your are burning at the same time as building. This must be turned off by schedule changes when the cooling season is ended and rescheduled in the spring. 
    6. 6

      Choir loft air handler operation

      Choir loft air handler is cooling only and to get it to run you can lower the thermostat temperature below the room temperature and it will run. The ice plant needs to be in burn and the thermostat in the sanctuary needs to be in cooling mode in order for the chilled water to circulate through the unit. If you don’t have those two items checked you’re just going to be circulating air. It is not necessary to operate this unit at any time the choir is not in the loft. Usually it is operated in the summer months to offset the heat from the lighting.
    7. 7

      Prayer Room

      5/9/18 Todd repaired the prayer room outdoor compressor by replacing a relay or capacitor.
    8. 8

      Sanctuary Univent maintenance

      Four of the Univents, two in the chapel, one by the prep room, hall door, and one by the south west Were rebuilt and the evaporator condensate tray have been cleaned and coated so they will not leak. This work was completed by Todd and John in and before 2023.

      In 5/2024 John and Sam completed coating all of the remaining condensate trays. They were able to remove the tray with the fan motors attached to make it a much quicker process. They did all of them in less than three days.

    9. 9

      Sanctuary Choir Loft, South air handler

      5/1/2024, John and Sam, with Debra replaced the blower motor. This is located in the ceiling above the East handicap access hallway.
    If you still have a question, we’re here to help. Contact us